Навчально-науковий центр "Мости та тунелі" (раніше Факультет "Мости і тунелі") ДІІТ
Permanent URI for this community
EN: Educational and Scientific Center (Faculty "Bridges and Tunnels") DIIT
Browse
Browsing Навчально-науковий центр "Мости та тунелі" (раніше Факультет "Мости і тунелі") ДІІТ by Author "Andrieiev, Volodymyr S."
Now showing 1 - 10 of 10
Results Per Page
Sort Options
Item Comparative Analysis of Calculation Results of Supporting Structure of Soil-Cement Piles(Kaunas University of Technology, Kaunas, 2019) Pshinko, Oleksandr M.; Petrenko, Volodymyr D.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.; Hubar, Oleksіy V.; Ihnatenko, Dmytro Yu.; Markul, Ruslan V.ENG: Abstract. The article presents the results of comparison of the stress-strain state of 4 models of a retaining wall structure of soil-cement piles on a landslide-prone slope. This study compares the changes in the stress distribution and displacements in the model elements of the retaining structure of soil-cement piles depending on the design parameters and the method of piles location in the body of the soil mass. The comparison of models of supporting structures of soil-cement piles on a landslide-prone slope allowed obtaining: –the comparative analysis of the quality work of individual elements of the supporting structure for strength and deformation in a three-dimensional representation; –the comparative assessment of the performance of the supporting structure of soil-cement piles on a landslide-prone slope; – histograms of dependences of changes in the angle of piles inclination to the vertical axis of their holding force, strength and deformation of the slope;Item Comparative Analysis of the Parameters of the Strength of the Subgrade at the Transition to the Higher Axial Loading up to 25 t(IOP Publishing, Kharkiv, 2019) Radkevych, Anatolii V.; Petrenko, Volodymyr D.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.; Mukhina, NataliyaENG: Abstract. A review of the scientific and technical literature on the re-alignment of the route during the transition to high axial load from the accepted today (23.5 t / axis) to the perspective (25 t / axis) shows that in the stage of preliminary researches imitation modeling of the earth web by the finite element method (ITU) as the most convenient, accurate and illustrative of the known numerical methods. In order to provide recommendations on the strength of the subgrade when moving to a higher axial load up to 25 t / axis, an analysis was conducted, the essence of which was to compare the stress-strain state of the subgrade at two loads per axis: 23.5 t / axis (existing ) and 25 (perspective). All the geometric and deformation characteristics of the formation are taken from data on a two-track section with a height of embankment of 3. The deformation characteristics are chosen so that the working material of the formation is in accordance with the average indices of deformation capacity of the railways used. The ITU train load calculus makes it possible to obtain all the factors of VAT in it, which is the main purpose of the study of the strength of the earth cloth, and allows to forecast their development in the future.Item Comparative Analysis of the Results of Calculating the Stability of a Reinforced Subgrade with Geosynthetic Materials(Kaunas University of Technology, 2021) Andrieiev, Volodymyr S.; Tiutkin, Oleksii L.; Hubar, Oleksіy V.; Markul, Ruslan V.ENG: Тhе article presents the results of studies of the stress-strain state of the reinforced and unreinforced railway subgrade. Тhis study compares changes in the distribution of stresses and displacements in а railway subgrade. Comparisons of stresses and displacements made it ossible to obtain: - comparative analysis of the work of the main site of the subgrade under increased load with reinforcement and without reinforcement; - comparative assessment ofthe efficiency ofthe reinforced subgrade at increased load; - isolines and isofields of displacements and stresses in the body ofthe embankment at an increased load.Item Improving the Safety of Railway Subgrade When it is Strengthened Using Soil-Cement Elements(Dnipro National University of Railway Transport named after Academician V. Lazaryan, 2019) Krysan, Vitalii; Krysan, Volodymyr; Petrenko, Volodymyr D.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.ENG: Abstract. The article identifies the main parameters of the drilling-mixing technology, which is the most effective in fixing weak soil bases during the construction and restoration of transport, industrial and civil structures. The difference of the technology developed by the authors is that the strengthening process is carried out at low pressure (0.15 ... 0.25 MPa). The relevance of the research is that the proposed technology requires less cost with high rates of restoring the strength of soil foundations. To prove the high quality of the technology, laboratory studies were carried out to determine the optimal characteristics of the soil-cement element, as well as the proportions and composition of the fixing solution. The dependences of the strength of soil-cement elements in the air-dry condition with cement content from 7% to 23% with water-cement ratio in solution 1 / 0.3 and with cement content from 13% to 37.5% with water-cement ratio in solution 1/0,6. During the experimental-industrial studies of the author's technology, the embankment was constructed with the soil-cement-reinforced elements for the access road approaches at one of the facilities in Kirovograd region, which ensured safety in the operation of a complex transport structure.Item The Influence of Geosyntetic Materials on the Strength in Uniaxial Compression of Soils of Railway Embasses(Kaunas University of Technology, Kaunas, Lithuania, 2023) Andrieiev, Volodymyr S.; Tiutkin, Oleksii L.; Hubar, Oleksіy V.; Mukhina, NataliyaENG: Many specialists were engaged in ensuring the stability of the soils of the embankments of the railway track. Most of them propose to ensure the stability of embankments due to its reinforcement. There is a need to generalize and adapt individual features of different calculation methods in order to obtain a single calculation model of the system "embankment - reinforcing layer - base" and "base site - reinforcing layer - ballast layer". The operation of reinforcing layers depends on the type of soil, the type of reinforcing material, and the shape of the structure. Geotextile layers in embankments perform a reinforcing function. They are used to reinforce the embankment in order to increase the overall stability of the embankment and the local stability of the slopes. The reinforcing function is determined by the ability of the geotextile layer to improve the working conditions of the soil for displacement due to its perception of tensile forces, friction of the layer against the soil and changes in the stress state in the soil massif.Item Investigation of the Operation of the Railway Track with Reinforced Concrete Sleepers in Curved Sections with Radius R ≤ 350 m(Printing House “Technologija”, Kaunas, Lithuania, 2020) Markul, Ruslan V.; Hubar, Oleksіy V.; Arbuzov, Maxim; Andrieiev, Volodymyr S.; Tiutkin, Oleksii L.; Savyts’kyy, V.; Ganich, Ruslan Ph.ENG: The article presents the results of the research on polygon extension for laying reinforced concrete sleepers under difficult conditions (R≤350 m, mountainous terrain) with ensuring safety traffic and reliable operation of the railway track. Changes in the geometry of the track in the plane with wooden sleepers and Д0 fastener as well as reinforced concrete sleepers with СКД65-Б fastener in the curve with the radius of 350 m were investigated. The results of the research allowed to obtain: - method and algorithm for determining the tapping section of the track gauge extension on reinforced concrete sleepers in curves with radius R ≤ 350 m; - comparative assessment of the track gauge change with the use of Д0 fastener (wooden sleepers) and СКД65-Б fastener (reinforced concrete sleepers) in curves with a radius R ≤ 350 m; - factors impact on the track gauge extension under difficult operating conditions; - empirical dependence of the process of the track gauge width change and the frequency of its adjustment in the cases of СКД65-Б fastener (reinforced concrete sleepers) and Д0 fastener (wooden sleepers) use in curves with radius R ≤ 350 m; - conclusions on the probability and feasibility of concrete sleepers use under mountainous terrain conditions, including difficult operating conditions (R ≤ 350 m).Item Methods of Assessment of Ballast Contamination on Railways of Ukraine(Technologija, Kaunas, 2022) Andrieiev, Volodymyr S.; Tiutkin, Oleksii L.; Hubar, Oleksіy V.; Markul, Ruslan V.; Mukhina, NataliyaENG: Ukrainian railways use a wide variety of methods for determining ballast contamination. Some regional branches of JSC "Ukrzaliznytsia" prefer to replace the old ballast with new instead of cleaning it. Others do the cleaning of crushed stone ballast. The periodicity of such crushed stone cleaning depends on local conditions and features of cargo transportation. Ballast contamination assessment plays an important role in this matter. The essence of the research is to reduce the time for obtaining results on the assessment of ballast contamination and to simplify it for use by one or two persons, who can act as track installers.Item On the Question of Choosing the Optimal Strength Criterion of Soils and Rocks(Kaunas University of Technology, Kaunas, 2021) Shashenko, Oleksandr; Shapoval, Volodymyr S.; Skobenko, O.; Zhylinska, S.; Andrieiev, Volodymyr S.; Markul, Ruslan V.; Mukhina, NataliyaENG: Based on the analysis of solutions to the classical problems of soil mechanics and geomechanics on determining the critical height and angle of the slope, as well as active and passive pressure on the enclosing structures, to identify the optimal strength criteria and the limits of their application, which allow predicting the destruction of ideally free-flowing, ideally plastic rocks, as well as rocks characterized by internal friction and specific cohesion, which is necessary for calculating the strength and stability of underground and open mine workings in the supercritical region - after the destruction of the near-contour region. The areas of application of some criteria for the strength of soils and rocks are outlined and substantiated. It is shown that, in contrast to the known strength criteria of Z.T. Benyavsky, Hoek - Brown and A.N. Shashenko Coulomb - Mohr strength criterion and our proposed modification of the strength criterion of A.N. Shashenko allow predicting the destruction of ideally - free flowing, ideally - plastic rocks, as well as rocks characterized by internal friction and specific cohesion.Item Relaxation of the Elastic Clamp in Rail Fastenings(Obuda University, Hungary, 2022) Arbuzov, Maxim; Tokariev, Serhii; Hubar, Oleksii; Andrieiev, Volodymyr S.; Suslov, VolodymyrENG: The main purpose of a rail fastening system is to provide the strength and reliability of joining rails to sleepers and, thus, prevents the longitudinal rail displacement and track disturbance. In a railway fastening, the joining function is performed by an elastic clamp. Over time, the clamping force of the elastic clamp is decreased due to various factors. The elastic clamp relaxation phenomenon is studied in present work. The observation of the clamp residual deformation was carried out on predetermined sleepers in different operating conditions. According to the research results of the elastic clamp relaxation of the rail fastenings, the following conclusions can be made: there is a relaxation process in the elastic clamps of the rail fastening, which has a curvilinear dependence on time; the intensity of the elastic clamps relaxation attenuates after one year of operation; in addition to the time factor, the relaxation of elastic clamps is influenced by the level of operating stresses; greater value of operating stresses corresponds to greater relaxation.Item Study of the Interaction of the Railway Track and the Rolling Stock Under Conditions of Accelerated Movement(IOP Publishing, 2020) Hubar, Oleksіy V.; Markul, Ruslan V.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.; Arbuzov, Maxim; Kovalchuk, O.ENG: Comprehensive studies of the interaction of the railway track and the investigated rolling stock under accelerated conditions have been carried out. The basis of the research was to obtain and substantiate the process of stress state, force interaction of the railway track and the rolling stock under conditions of accelerated movement. Introduction of the new rolling stock into continuous operation is a serious task that must be solved comprehensively. The implementation of this direction significantly affects the reliability of the elements of the railway track. Within the framework of the research, the approach was used that takes into account theoretical and experimental parts of the research using the methodology of prof. O. P. Yershkov. As a result of the studies, average stress values were established: in rails, they variate within the range 44.37...70.99 MPa; in the sleeper, they reach 0.78 MPa; in the ballast layer, they have 0.13 MPa; in the body of the subgrade, they reach 0.04 MPa, which is significantly less than the maxima allowable values. While speed change from 140 to 160 km/h, the values of the studied parameters decrease: vertical force (9.39 %), lateral forces (19.79 %); stresses in the edge of the rail flange (15.86 %); stresses in the edge of the rail head (16.67 %); stresses in the neck of the rail (8.74 %). The obtained results made it possible to form trends and recommendations on the feasibility of further increasing speeds development. At the same time, this made it possible to substantiate in more detail the operation of the railway track in the case of accelerated movement.